It is specifically used for professional replacement of the fixture set;
① First place the fixture set on the gripping machine to obtain parallel lines. Then adjust the club with the front forward, adjust the telescopic plate, so that the back of the grip may be placed above the plastic pot.
② Pull the wrench and clamp the club;
③ Tear off the required length of the double-sided adhesive and spread it on the rear end of the club;
④ Wrap the rear end of the club with double-sided double faced adhesive tape to keep it smooth and flat;
⑤ Block the hole of the handle, pour a small amount of solution in the grip inside, gently shake, loose the blocked hole and put the handle on the club.
⑥ Please make sure three points are kept in the same line, no skewed and with the font up and with the rear end to the bottom.